SATO CL408e - ESC+RM Mirror Rotate

38
7.16 Modification
Printer
CL408e/412e
M-8400RVe
CL608e/612e
M-5900RVe
M-10e
M-8485Se/90Se/60Se/59Se M-84Pro-2/3/6 LC408e/412e
7.16 ESC+RM Mirror Rotate
ESC+RM
HEX Code
ESC
RM
Parameter
<1B>16
<52>16<4D>16
aaaa,bbbb
Default Value
NIL
Valid Range &
Terms of
Command
When Power is Switched Off
The set parameter is not maintained
Valid Range within Items
The set parameter becomes invalid
Valid Range between Items
The set parameter becomes invalid
[Function]
Mirror rotate the print data
[Format]
<H>hhhh<V>vvvv<RM>aaaa,bbbb
● Parameter
h {Mirror Rotate Specification Start Horizontal Position} = valid range : refer to next page table
v {Mirror Rotate Specification Start Horizontal Position} = valid range : refer to next page table
a {Mirror Rotate Specification Horizontal Range} = valid range : 8~9999
b {Mirror Rotate Specification Vertical Range} = valid range : 8~9999
[Coding Example 1] When Mirror Rotate Range is specified
<A>
<H>100<V>100<XM>12345
<H>100<V>100<RM>0200,0080
<Q>1
<Z>
[Coding Example 2] When Mirror Rotate Specification is not specified
<A>
<H>100<V>100<XM>12345
<RM>
<Q>1
<Z>
[Supplementary Explanation]
1. When parameter of aaaa, bbbb is not specified, all specified print data before Mirror Rotate Specification <RM> is mirror rotated.
2. Data not inside of the print area will not be mirror rotated.
3. For item not inclusive of print data, if this command is specified, it will become command error.
4. This command cannot be applied together with command (sequential number specification <F>, within label copy <WD>, calendar
print specification <WA> etc) that inclusives of re-editing of print data. And also the graphic registration specification <GI>, format
1. registration specification <YS>, data registration commands.
5. Multiple specification cannot be conducted with less than 1 item under this command.
Mirror Rotate