[Function]
To specify black/white inversion printing
[Format]
<(>aaaa,bbbb
● Parameter
a {Inverse Area of Horizontal Direction Specification} = valid range : refer to the following table
b {Inverse Area of Vertical Direction Specification} = valid range : refer to the following table
[Coding Example] Horizontal Direction Inverse Area:200, Vertical Direction Inverse Area:70
<A>
<V>50<H>50<P>2<L>0202<XM>ABC
<V>50<H>50<(>200,70
<Q>2
<Z>
[Supplementary Explanation]
1.Print start position specify Print Horizontal Position Specification <H> and Print Vertical Position Specification <V> before the
Black/White Inversion Print Specification <(>.
2.If print start positin exceed print valid range, it will become command error and stop printing.
[Point]
1.Set the black print portion not exceed 30% of overall label.
[Valid Range]
To Next Page
Loading...
