SATO CL408e - ESC+PC Printer Motion Register

220
12.15 System
Printer
CL408e/412e
M-8400RVe
CL608e/612e
M-5900RVe
M-10e
M-8485Se/90Se/60Se/59Se
M-84Pro-2/3/6
LC408e/412e
12.15 ESC+PC Printer Motion Register
ESC+PC
HEX Code
ESC
PC
Parameter
<1B>16
<50>16<43>16
1)
｢
a, b, c, d, ···y, z
｣
, 2)
｢
aa, b
｣
Default Value
Refer to next page table onwards
Valid Range &
Terms of
Command
When Power is Switched Off
The set parameter is maintained
Valid Range within Items
The set parameter is valid until the next specification is made.
Valid Range between Items
The set parameter is valid until the next specification is made.
[Function]
To register printer motion into EEPROM
[Format 1]when perform setting of all items
<PC>a,b,c,d,e,f,g,h,i1,i2,j,k,l,m,n,o,pppp,qqqq,rrrr,ssss,t,u,v,w,x,y,z
● Parameter
a {Setting Item Number} = F Setting of all items
b···z {Setting Content} = Content of parameter can be referred to next page table onwards
[Format 2]when perform setting of specified items
<PC>aa,b
● Parameter
a {Setting Item Number} = valid range : 1~26
b {Setting Content} = Content of parameter can be referred to next page table onwards
[Coding Example 1] Set all items
<A>
<PC>F,,,2,,,,,A,4,,1,0,,1,1,3000,2400,,,,,,,,,1
<Z>
[Coding Example 2] Set all items
<A>
<PC>26,1
<Z>
[Supplementary Explanation]
1.Normally it is set at LCD advanced mode, service mode.
2.The motion setting that is specified at Printer Motion Register Specification <PC> can be maintained even if printer power is switched OFF.
3.When set all items, part of or entireof the parameter input can be omitted. However, comma cannot be omitted.
The omitted setting becomes default (remain as present)
Printer Motion Register