SATO CL408e - ESC+E Automatic Line Feed

223
12.16 System
Printer
CL408e/412e
M-8400RVe
CL608e/612e
M-5900RVe
M-10e
M-8485Se/90Se/60Se/59Se
M-84Pro-2/3/6
LC408e/412e
12.16 ESC+E Automatic Line Feed
ESC+E
HEX Code
ESC
E
Parameter
<1B>16
<45>16
aaa
Default Value
aaa=0
Valid Range &
Terms of
Command
When Power is Switched Off
The set parameter is maintained
Valid Range within Items
The set parameter becomes invalid
Valid Range between Items
The set parameter becomes invalid
[Function]
To specify line pitch and new line
[Format]
<E>aaa
● Parameter
a {Line Pitch Width} = valid range : 0~999 (dot)
[Coding Example]
<A>
<E>10
<V>100<H>200<P>2<L>0304<XM>ABCDE+CR
FGHIJ+CR
<Q>2
<Z>
[Supplementary Explanation]
1.When CR(0DH)is specified, a line feed is given to only the specified pitch.
2.Rotate Specification <%> is valid.
3.Line pitch changes is valid from Automatic Line Feed Specification <E> among items.
4.Specify Automatic Line Feed Specification <E> before specifying the repeat printing of a line.
5.Auto line feed is performed by continuing CR(0DH)specification, however, the beginning print position of new line is determined by value of Print
Horizontal Position Specification <H> after pitch of Automatic Line Feed Specification <E> and Automatic Line Feed Specification<E>.
However, when multiple Print Horizontal Position Specification <H> is specified after this command, the position to return to CR(0DH)becomes the last
position of Print Horizontal Position Specification <H>.
Automatic Line Feed