SATO CL408e - 12 System Command; ESC+CS Print Speed

202
12. System Command
12.1 System
Printer
CL408e/412e
M-8400RVe
CL608e/612e
M-5900RVe
M-10e
M-8485Se/90Se/60Se/59Se M-84Pro-2/3/6 LC408e/412e
12.1 ESC+CS Print Speed
ESC+CS
HEX Code
ESC
CS
Parameter
<1B>16
<43>16<53>16
aa
Default Value
Refer to the table below
Valid Range &
Terms of
Command
When Power is Switched Off
The set parameter is maintained
Valid Range within Items
The set parameter is valid until the next specification is made.
Valid Range between Items
The set parameter is valid until the next specification is made.
[Function]
To specify the print speed
[Format]
<CS>aa
● Parameter
a {Print Speed} = refer to the table below
[Coding Example]
<A>
<CS>3
<Z>
[Supplementary Explanation]
1. Print speed value that is set directly from command or printer LCD will be maintained.
[Point]
1.If value out of setting range is specified, it become command error but print speed will not change.
2.Print speed can be set at default value at printer default set operation.
[Parameter Default Value and Specified Range]
Model
Default
Value
Parameter Valid
Range
Print Speed against Parameter
LC408e/412e 3 1,2,3,4,5
1 : 2 inch/sec (50mm/sec)
2 : 3 inch/sec (75mm/sec)
3 : 4 inch/sec (100mm/sec)
4 : 5 inch/sec (125mm/sec)
5 : 6 inch/sec (150mm/sec)
CL408e/412e 3 1,2,3,4,5
M-84Pro-6 2 1,2,3,4,5
M-8400RVe 3 1,2,3,4,5
1 : 2 inch/sec (50mm/sec)
2 : 4 inch/sec (100mm/sec)
3 : 6 inch/sec (150mm/sec)
4 : 8 inch/sec (200mm/sec)
5 : 10 inch/sec (250mm/sec)
M-84Pro-2 3 1,2,3,4,5
M-84Pro-3 3 1,2,3,4
M-5900RVe 3 2,3,4,5,6
2 : 2 inch/sec (50mm/sec)
3 : 3 inch/sec (75mm/sec)
4 : 4 inch/sec (100mm/sec)
5 : 5 inch/sec (125mm/sec)
6 : 6 inch/sec (150mm/sec)
7 : 7 inch/sec (175mm/sec)
8 : 8 inch/sec (200mm/sec)
10 : 10 inch/sec (250mm/sec)
12 : 12 inch/sec (300mm/sec)
CL608e/612e 6 4,6,8
M-10e 4 3,4,5
M-8485Se 6 4,6,8,10,12
M-8490Se 6 4,6,8
M-8460Se 6 4,6,8
M-8459Se 4 2,3,4,5
Print Speed