SATO CL408e - ESC+0 Part Editing Function

33
7.12 Modification
Printer
CL408e/412e
M-8400RVe
CL608e/612e
M-5900RVe
M-10e
M-8485Se/90Se/60Se/59Se M-84Pro-2/3/6 LC408e/412e
7.12 ESC+0 Part Editing Function
ESC+0
HEX Code
ESC
0
Parameter
<1B>16
<30>16
NIL
Default Value
NIL
Valid Range &
Terms of
Command
When Power is Switched Off
The set command is not maintained
Valid Range within Items
The set command becomes invalid
Valid Range between Items
The set command becomes invalid
[Function]
To specify part editing from the previous print data
[Format]
<0>
[Coding Example] Edit part of print Data{DEF} into{123}
<A>
<V>100<H>200<P>2<L>0202<XM>ABC
<V>200<H>200<P>2<L>0202<XM>DEF
<Q>1
<Z>
<A>
<0>
<V>200<H>200<P>2<L>0202<XM>123
<Q>1
<Z>
[Supplementary Explanation]
1. Used when only one part of the previous print data is changed.
2. Recall the previous print data by Part Edit Specification <0>, start printing after part editing. From previous data, specify changes
on the same print position, the condition is to send the changed data.
3. The specified previous data at the same position is cleared.
4. If Rotate Specification <%> is applied on edit portion, it is necessary to be applied during part editing too.
5. This command is used with the fixed pitch, same font or same digit numbers.
ABC
DEF
ABC
123
1
st
label
2
nd
label
Part
Editing
1
st
label
Label Feed Direction
2
nd
label
Part Editing Function