[Function]
To specify vertical text flow kanji at width 24 X height 24 dot.
[Format]
<k2>an~n
● Parameter
a {Kanji Specification Mode} = H : HEX Character Specification
B : Binary Code Specification
I : with smoothing function based on HEX
C : with smoothing function based on binary code
J : with highlighting function base on HEX
D : with highlighting function based on binary code
K : with smoothing and highlighting function based on HEX
E : with smoothing and highlighting function based on binary code
n {Data} = Refer to JIS Kanji Code Table or Shift JIS Kanji Code Table
[Coding Example 1] HEX Character Specification of Shift JIS, horizontal direction ratio:3 times, vertical direction ratio:5 times
<A>
<k2>H81698A94816A83548367815B
<Q>2
<Z>
[Coding Example 2] Binary Specification of JIS, horizontal direction ratio:2 times, vertical direction ratio:3 times
<A>
<k2>B!J3t!K%5%H!<
<Q>2
<Z>
[Supplementary Explanation]
1.HEX Character = Kanji Code 4 byte ASCII/Kanji 1 character
2.Binary Code = Kanji Code 2 byte/Kanji 1 character
3.Smoothing Function Valid Ratio = Horizontal, Vertical valid range : 3~12 times
4.Highlight Fucntion Valid Ratio = Horizontal, Vertical valid range : 1~5 times
[Point]
1.For the highlighting function, the horizontal width of characters increase if follow the enlargement specification.
2.If highlighting function is used, be aware as there might have smearing problem occurs due to the characters.
3.This command can be used only when option Kanji ROM is installed.
[Valid Command]
To Next Page
Loading...
