SATO CL408e - Page 76

76
8.17 Font
Printer
CL408e/412e
M-8400RVe
CL608e/612e
M-5900RVe
M-10e
M-8485Se/90Se/60Se/59Se M-84Pro-2/3/6 LC408e/412e
8.17 ESC+k8 16X
16 dot Vertical Text with
Mixture of Half-sized, Full-
sized Kanji (Valid
Specification of Shift JIS)
ESC+k8
HEX Code
ESC
k8
Parameter
<1B>16
<6B>16<38>16
an~n
Default Value
NIL
Valid Range &
Terms of
Command
When Power is Switched Off
The set parameter is not maintained
Valid Range within Items
The set parameter becomes invalid
Valid Range between Items
The set parameter becomes invalid
[Function]
To specify mix specification of width 16 X height 16 dot vertical text with width 8 X height 16 dot half-sized character.
[Format]
<k8>an~n
● Parameter
a {Kanji Specification Mode} = H : HEX Character Specification
B : Binary Code Specification
I : with smoothing function based on HEX
C : with smoothing function based on binary code
J : with highlighting function base on HEX
D : with highlighting function based on binary code
K : with smoothing and highlighting function based on HEX
E : with smoothing and highlighting function based on binary code
n {Data } = Refer to Shift JIS Kanji Code Table
[Coding Example] HEX Character Specification of Shift JIS, horizontal direction ratio:3 times, vertical direction ratio:5 times
Data:SATO Corporation
<A>
<V>100<H>200<P>2<L>0305
<k8>H8A948EAE89EF8ED0BBC42D
<Q>2
<Z>
[[Supplementary Explanation]
1.HEX Character = Kanji Code 4 byte ASCII/Kanji 1 character
2.Binary Code = Kanji Code 2 byte/Kanji 1 character
3.Smoothing Function Valid Ratio = Horizontal, Vertical valid range : 3~12 times
4.Highlight Fucntion Valid Ratio = Horizontal, Vertical valid range : 1~5 times
[Point]
1.For the highlighting function, the horizontal width of characters increase if follow the enlargement specification.
2.If highlighting function is used, be aware as there might have smearing problem occurs due to the characters.
3.The valid specification of 16 X 16 dot vertical text with mixture of half-sized, full-sized kanji specification <k8> is limited for Shift JIS Kanji
Code only.
4.Hafl-sized specification (character code of 1 byte) is printed out at size of 8x16 dot.
5.Full-sized specification (character code of 2 byte) is printed out at size of 16X16 dot.
6.Half-sized character has no relation with Kanji Gothic Style Specification <KG>, it is printed out by Mincho Style.
7.This command can be used only when option Kanji ROM is installed.
[NOTE]
1. When characters with a sonant mark/half sonant mark at half-sized specification is choosen, characters and part of sonant mark/half
sonant mark turns out to be different printing.
Example: if{ﾊﾞｰ}is specified, it comes out with{ﾊ}{ﾞ}{-}.
[Valid Command]
Print Position
<V>
<H>
Modification
<P>
<L>
<%>
<&>
</>
<0>
<WD>
16 x 16 dot Vertical Text with Mixture of Half-sized,
Full-sized Kanji
(Valid Specification of Shift JIS)
ﾊ
ﾞ
-