【Function】
To specify the content registration to be printed on tag when RFID tag error occur.
【Format】
＜RZ＞a
● Parameter
a 「Print Pattern」 ＝ 0：Diagonal Line + Character
1：Diagonal Line only
2：Character only
【Coding Example】 To print message (XM Character) of『No RFID Label』and diagonal line.
＜A＞
＜A1＞08000600
＜V＞50＜H＞50＜XM＞No RFID Label
0
＜Z＞
【Print Example】
【Supplementary Explanation】
1． Become valid only for CL408e/412e with installation of RFID Option.
2． Label size specification <A1> must be set. When label size specification is not available, vertical 800 dot, horizontal 600 dot is
specified.
If specified label size is bigger than actual label, print message will be printed onto the next tag.
3． RFID Message Print Registration Specification <RZ> cannot be specified within the item similar to normal print data. If Print
Number Specification <Q> is specified within the item that is specified under this command, print number specification become
invalid.
4． Specify RFID Message Print Registration Specification <RZ> right before Data Send End Specification <Z>.
5． If this command is not specified, the word of “RFID TAG ERROR” and diagonal line will be printed when RFID Tag Error Occur.
6． Diagonal line will be printed automatically by Label Size Specification <A1> after adjusted to the specified label size. But the shape
and print position of the line cannot be specified.
【Valid Command】
To Next Page
Loading...
