SATO CL408e - ESC+PG Printer Motion Register

217
12.14 System
Printer
CL408e/412e
M-8400RVe
CL608e/612e
M-5900RVe
M-10e
M-8485Se/90Se/60Se/59Se M-84Pro-2/3/6 LC408e/412e
12.14 ESC+PG Printer Motion Register
ESC+PG
HEX Code
ESC
PG
Parameter
<1B>16
<50>16<47>16
abcdefghhijklmnooppqqrrstuvwxy
Default Value
Refer to next page table onwards
Valid Range &
Terms of
Command
When Power is Switched Off
The set parameter is maintained
Valid Range within Items
The set parameter is valid until the next specification is made.
Valid Range between Items
The set parameter is valid until the next specification is made.
[Function]
To register printer motion into EEPROM
[Format]
<PG>abcdefghhijklmnooppqqrrstuvwxy
● Parameter
Parameter content can be referred to next page table onwards
[Coding Example]
<A>
<PG><00 00 02 00 00 00 00 41 01 00 00 00 00 00 00 0C 80 03 40 00 00 00 00 00 00 00 00 00 00 00>16
<Z>
Parameter value becomes hexadecimal <00>
16<00>16<02>16······<00>16
[Supplementary Explanation]
1.It is not necessary to specify Printer Motion Register Specification <PG> for normal label print.
2.Motion setting that is specified at Printer Motion Register Specification <PG> can be maintained even if printer power is switched off.
[Point]
1.Although Printer Motion Register Specification <PG> is not used, setting can be performed from LCD advanced mode, service mode.
Printer Motion Register