SATO CL408e - ESC+A3 Correction Pitch

206
12.4 System
Printer
CL408e/412e
M-8400RVe
CL608e/612e
M-5900RVe
M-10e
M-8485Se/90Se/60Se/59Se M-84Pro-2/3/6 LC408e/412e
12.4 ESC+A3 Correction Pitch
ESC+A3
HEX Code
ESC
A3
Parameter
<1B>16
<41>16<33>16
VabbbbHcdddd
Default Value
NIL
Valid Range &
Terms of
Command
When Power is Switched Off
The set parameter is maintained.
Valid Range within Items
The set parameter is valid until the next specification is done.
Valid Range between Items
The set parameter is valid until the next specification is done.
[Function]
To specify the change of coordinate of the standard start point. Normally it is set at LCD advanced mode.
[Format]
<A3>VabbbbHcdddd
● Parameter
a {V Correction Pitch Symbol} (omittable) = +, -
b {V Direction Correction (dot)} = refer to next page table
c {H Correction Pitch Symbol} (omittable) = +, -
d {H Direction Correction (dot)} = refer to next page table
[Coding Example]
<A>
<A3>V10H10
<Z>
[Supplementary Explanation]
1.Perform correction pitch arbitrarily, be aware when printing cannot be performed due to exceeding print valid area.
2.Perform correction pitch by using multiple lable format, be aware when all of the label format will be performed correction pitch.
[Point]
1. When print correction pitch is performing at the LCD advanced mode, correction pitch is specified at the correction pitch
specification <A3>, the value that is specified at the correction pitch specification <A3> will become valid.
2. Correction pitch value that is specified at the correction pitch specification <A3> will be registered at the LCD advanced
mode.Therefore, correction pitch value that is specified at correction pitch specification <A3> will be maintained even if printer
power is switched OFF.
Correction Pitch
Label Feed Direction
Start Point After Specified
Start Point Before Specify
H V