Schweitzer Engineering Laboratories SEL-749M - Terminal; Figure 3.3 Tools Menu; Figure 3.4 Device Response to the ID Command

3.3
Date Code 20080918 Instruction Manual SEL-749M Relay
PC Software
Termina l
Step 4. Configure ACSELERATOR QuickSet to match the SEL-749M
default settings by entering Access Level 1 and Access Level 2
passwords in the respective text boxes.
Step 5. If a telephone modem is chosen from the
relay text box, enter
the dial-up telephone number in the Phone Number text box.
Step 6. Exit the menus by clicking OK when finished.
Terminal
Terminal Window
Select Tools > Terminal on the ACSELERATOR QuickSet main menu bar to
open the terminal window (shown in Figure 3.3).
Figure 3.3 Tools Menu
The terminal window is an ASCII interface with the relay. This is a basic
terminal emulation. Many third-party terminal emulation programs are
available with file transfer encoding schemes. Open the terminal window by
either clicking Tools > Terminal or by pressing <Ctrl+T>. Verify proper
communications with the
relay by opening a terminal window, pressing
<Enter> a few times, and verifying that a prompt is received. If a prompt is
not received, verify proper setup.
Terminal Logging
To create a file that contains all terminal communications with the relay, select
Terminal Logging in the Log menu, and specify a file at the prompt.
ACSELERATOR QuickSet records communications events and errors in this
file. Click Log > Connect Log to view the log. Clear the log by selecting
Log > Clear Connection Log.
Drivers and Part
Number
After clicking Tools > Ter mina l, access the relay at Access Level 1. Issue the
ID command to receive an identification report, as shown in Figure 3.4.
=>ID <Enter>
“FID=SEL-749M-X156-V0-Z003003-D20070223”,”0904”
“BFID=BOOTLDR-R101-V0-Z000000-D20030612”,”0942”
“CID=4BCA”,”0277”
“DEVID=SEL-749M”,”041B”
“DEVCODE=59”,”0315”
“PARTNO=0749M01B500X1X1X”,”0644”
“CONFIG=11111001”,”03E9”
=
Figure 3.4 Device Response to the ID Command
Courtesy of NationalSwitchgear.com