Sennheiser Digital 6000 - Using the Headphone Output

Using the EM 6000
113
Using the headphone output
You can use the headphone output on the front of the EM 6000 (6.3 mm
jack) to listen to the audio signals of the two channels.
ATTENTION
Danger due to high volume levels
Volume levels that are too high may damage your hearing.
▷ Turn down the volume of the headphone output before you put on the
headphone.
►
▷ Connect the headphone to the HEADPHONES socket.
▷ Press the headphone button on one of the two channels CH 1 or CH
2 to listen to that channel.
▷ Press both headphone buttons for the two channels to listen to both
channels at the same time.
▷ Control the volume by turning the VOLUME control next to the HEAD-
PHONES socket.