Installing the L 6000 | LM 6060 | LM 6061
59
Installing the L 6000 in a rack
You can install the L 6000 charger in any conventional 19" rack. The rack
mounting angles are already attached to the device.
Always observe the following information during rack mounting.
▷ Support the L 6000 charger after installation in the rack.
Due to the weight and depth of the device, there is a risk that it may
break off in the rack and become damaged as a result.
►
Version A:
▷ Use special rack mounting rails.
▷ The design of the rack used must be suitable for the installation of
these mounting rails.
Version B:
▷ Use a suitable object to support the device on the rear side.
▷ Ensure that this object cannot become loose.
ATTENTION
Material damages caused by devices overheating
When there is insufficient ventilation, the devices mounted in the rack may
overheat.
▷ Ensure that there is sufficient ventilation in the rack, particularly if sev-
eral devices are installed. If necessary, install a fan in the rack.
►
To Next Page
Loading...
