Using the EM 6000
73
Setting options in the menu
In the EM 6000 menu, you can configure the following settings.
►
You can find an overview of the entire menu structure under “Menu
structure”.
Adjusting frequencies
▷ See “Frequency menu item”
Setting up user-defined frequency banks
▷ See “Bank Edit menu item”
Changing link names
▷ See “Name menu item”
Configuring settings that are transferred to the transmitter during a
sync
▷ See “Sync Settings menu item”
Activating and deactivating encryption
▷ See “Encryption menu item”
Performing a frequency scan and automatic frequency setup
▷ See “Scan & Auto-Setup menu item”
Performing a walk test
▷ See “Walktest menu item”
Adjusting the output level of the receiver audio signal
▷ See “AF Output menu item”
Playing back a test tone
▷ See “Test Tone menu item”
Configuring different system settings
• Configuring wordclock
• Configuring network settings
• Changing device names
• Configuring Dante settings (only EM 6000 DANTE)
• Activating the power supply for an external antenna amplifier
• Changing the brightness of the display panel
• Activating the auto-setup function
• Displaying information about software and hardware
• Updating the firmware for the transmitters
• Resetting settings
▷ See “System menu item”
To Next Page
