Using the EM 6000
92
Walktest menu item
Once you have set up and installed all of the receivers and transmitters for
your event, we recommend performing a walk test. This lets you check
whether sufficient reception strength is available throughout the entire
area used.
Start the walktest function in this menu item and then walk the entire area
with one transmitter. The results of the walk test give you information
about the reception quality.
To open the Walktest menu item:
▷ On the home screen, press the jog dial to open the operating menu.
▷ Turn the jog dial until the Walktest menu item appears in the selection
frame:
►
▷ Press the jog dial to open the menu.
The following view is displayed:
►
The Start option in the top left of the display is already highlighted for se-
lection.
▷ Press the jog dial to start the walk test.
▷ Walk the entire area on which you want to operate the system with the
transmitter.
To Next Page
Loading...
