Using the EM 6000
78
Sync Settings menu item
In the Sync Settings menu item, you can choose which settings for the
transmitter you want to transfer from the receiver to the transmitter during
the synchronization.
All of the settings can also be set separately in the menu on the transmitter.
However, you can simply use the Sync function to configure these settings
via the receiver.
For more information about the Sync function, see “Synchronizing
devices”.
The following settings can be transferred:
►
If you do not want to transfer all of these values to the transmitter,
you can also set the no sync value for each option. The option in
question is then not included in the synchronization.
Option Possible setting
Gain Gain setting for the transmitter, from -6 to 60 dB
Low Cut Low cut filter, from 30 Hz to 120 Hz
Auto Lock Activate or deactivate the lock-off on the transmitter
Display panel Display on the home screen of the transmitter dis-
play panel
• Name of the link
•Frequency
•Preset
Cable Cable emulator in 4 steps
•Line
•Type 1
•Type 2
•Type 3
To Next Page
Loading...
