Using the EM 6000
114
Updating the firmware of the receiver
You can update the firmware for the EM 6000 receiver using the Sennhe-
iser Wireless Systems Manager (WSM) software.
▷ To do so, connect the EM 6000 to a network (see “Connecting the
EM 6000 to a network”) and establish the connection with the WSM
software.
For more information about controlling devices via the Sennheiser
Wireless Systems Manager (WSM) software, refer to the instruction
manual for the software. You can download the software at
www.sennheiser.com/download.
The firmware for the Dante™ interface of the EM 6000 DANTE cannot be
updated via WSM. See “Updating the firmware of the Dante™ interface”.
Updating the firmware of the Dante™ interface
To update the Dante™ interface (Audinate Brooklyn II) for the
EM 6000 DANTE, you require the Firmware Updater software from Audi-
nate.
You can access it using the link below:
https://www.audinate.com/products/firmware-update-manager
▷ To update the firmware, connect your computer to the Dante™ inter-
face of the EM 6000 DANTE with a network cable.
To Next Page
Loading...
