Installing the L 6000 | LM 6060 | LM 6061
58
To install a charging module in the L 6000 charger:
▷ Completely disconnect the L 6000 charger from the power supply sys-
tem. See “Connecting/disconnecting the L 6000 to/from the power
supply system”.
▷ Unscrew one of the dummy caps on the L 6000.
To do so, you require a Torx 10 screwdriver.
►
▷ Fully slide the charging module into the open charging slot as shown in
the figure.
The charging module can be inserted into the L 6000 housing only in
one direction. The Sennheiser lettering on the charging module must
face upward.
►
▷ Tightly screw on the charging module.
For more detailed information about charging the BA 60 and BA 61
rechargeable batteries, see “Charging rechargeable batteries”.
To Next Page
Loading...
