Distance and angle measurement
9-66
9
Continued on the following page
Continued from the previous page: GRAY&EDGE, GRAV.
Angle: When a 2-point (horizontal) angle
is specified
Point 2
Angle: When a 2-point (vertical) angle is
specified
Point 1
Point 2
If auxiliary point settings have been
made in the [AUX.CONDITIONS]
(auxiliary condition) menu, then they
may be used for the measurement
Angle: When a 3 point angle is specified
Point 1
+Angle (〜+180.0¡)
+Angle (-180.0¡〜)
Point 1
Horizontal line
Vertical line
Point 2
Point 3
Point 2
Point 3
Point 1
+angle
+angle
Point 1 is the point of intersection of the two lines. Relative to the line between points 1 and 2, the
line between points 1 and 3 will be said to be at a positive angle if the angle is measured in a
counterclockwise direction, and it will be at a negative angle if it is measured in a clockwise
direction.
Relative to the horizontal line, the line from
point 2 that intersects point 1 will be said to
at a positive angle if the angle is measured
in a counterclockwise direction and at a
negative angle if it is measured in a
clockwise direction.
Relative to the vertical line, the line from point 2
that intersects point 1 will be said to at a
positive angle if the angle is measured in a
counterclockwise direction and at a negative
angle if it is measured in a clockwise direction.
Items
3
and
4
will be displayed unless NO is selected in item 2.
If 3PT-ANGL (3 point angle) is selected in item
2
, then item 5 will be displayed.
Return to the [MEASURING COND] (measurement conditions) menu and select item 7 UPPER MENU
[ANGLE SETTINGS] (TYPE00-MEAS.1-DST&ANGL MEAS)
1ANGLE NO. 00(0~15)
2ANGLE TYPE NO 3PT-ANGL 2PT-ANGL(HORI VERT)
3POINT NO.1 : ST-PNT00 AUX.NO
4POINT NO.2 : ST-PNT00 AUX.NO
5POINT NO.3 : ST-PNT00 AUX.NO
6UPPER MENU
Angle settings
1ANGLE NO.
2ANGLE TYPE
3POINT NO.1
4POINT NO.2
5POINT NO.3
6UPPER MENU
Setting details
Set the angle number to any number from 0 to 15
Select either a 3-point angle (3 points of data are required) or a 2-point
angle (horizontal and vertical).
Enter the starting point number for the angle type to be measured, as
specified in item 2.
This will return you to the [MEASURING COND] menu.
To Next Page
Loading...