9-88
Area measurement by binary conversion
9
· The input signals which may be set depend on the selection made at item 3 as follows.
The numbers ranging from 00 to 15 in front of A are registration numbers.
· For more information on output condition, see the PC Function, in Chapter 10.
Continued from the previous page
Return to the MAIN OPS MENU
DEL.
[OUTPUT CONDITIONS]
(TYPE00-MEAS.1-MEAS-BIN-AREA)
1PAGE NO. 0(0~4) REG.NO YES
2SET POSITION MOVE
3INPUT SIGNAL T-AREA A00(0~15)
CAL N00(0~15) AUXRLY C000(0~127)
4LOGICAL SYMBOL
5OUTPUT SIGNAL AUX.RLYC000(0~127) DEL.
6UPPER MENU
[PAGE0]
INPUT0
LOGIC
INPUT1
LOGIC
INPUT2
LOGIC
INPUT3
LOGIC
10 234567OUT
Continued on the following page
Selection of 3
Total area A
Calculation N
Secondary relay C
Input signals
00A to 15A
N00 to N15
C000 to C127
To Next Page
Loading...
Need help?
General