Shimadzu LC-40D XR CL - Page 44

n Setting the flow path of the mobile phase switching valve connected to the back of
the instrument《EXT.SV PORT CH1 / CH2 / CH3》
Not used in CL model.
Do not change the factory default value.
n Setting the EVENT1 output terminal《EVENT1》
Not used in CL model.
Do not change the factory default value.
Set "ON" (close) / "OFF" (open) of the
[EVENT1] output (relay contact) on the
back of the instrument.
Set
Value
EVENT1 Output
0 Relay 1 OFF
1 Relay 1 ON
n Setting the EVENT2 output terminal《EVENT2》
Not used in CL model.
Do not change the factory default value.
Set "ON" (close) / "OFF" (open) of the
[EVENT2] output (relay contact) on the
back of the instrument.
Set
Value
EVENT2 Output
0 Relay 2 OFF
1 Relay 2 ON
34
LC-40D X3 CL LC-40D XR CL
3 Operation