Shimadzu LC-40D XR CL User Manual

1.3 Optional Parts
Optional units available for this instrument are listed below.
For information about other optional units listed below, contact your Shimadzu
representative.
n Common Optional Parts for LC-40D X3 CL/LC-40D XR CL
Option Part No. Features
Low pressure gradient
kit
228-65016-58
Switches between up to 4 liquids of low-pressure
gradient or mobile phase. It also can be used for
auto rinsing of column flow lines.
Installed inside of the instrument.
Reservoir switching
valve
228-65017-58
• Switches between 2 liquids (for example,
switches between mobile phase and rinse
solution) or two mobile phases.
• Installed inside of the instrument.
Mixer installation kit
(MR40 LPGE, to be
built in)
(w/ mixer
recognition
device)
228-65020-41
Gradient mixer (40 µL internal capacity)
exclusively for low-pressure gradient analysis.
Fixed inside of the instrument.
Mixer MR40 LPGE
(fixed inside column
oven)
(w/o mixer
recognition
device)
228-45210-41
Gradient mixer (40 µL internal capacity)
exclusively for low-pressure gradient analysis.
It can be installed inside of the CTO-40C CL.
Mixer MR300 LPGE
(w/ mixer
recognition
device)
228-72653-42
(w/o mixer
recognition
device)
228-45210-42
Gradient mixer (300 µL internal capacity)
exclusively for low-pressure gradient analysis.
It can be installed inside of the CTO-40C CL.
This option can be used for solvents that are
hard to mix, such as TFA (trifluoroacetic acid), or
for reducing the baseline fluctuation of the
photo diode array detector.
Gradient Mixer for
High-Pressure Gradient
Analysis
"Gradient Mixer for High-Pressure Gradient Analysis" P.5
LC-40D X3 CL LC-40D XR CL
3
1.3 Optional Parts
1

Shimadzu LC-40D XR CL Specifications

General

Brand	Shimadzu
Model	LC-40D XR CL
Category	Laboratory Equipment
Language	English