Shimadzu LC-40D XR CL User Manual

n Gradient Mixer for High-Pressure Gradient Analysis
The following gradient mixers for high-pressure gradient analysis are available for liquid
chromatographs.
Part Name Part No.
MIXER,MR 20 µL
(w/ mixer recognition device) 228-72652-41
(w/o mixer recognition device) 228-45209-41
MIXER,MR 40 µL
(w/ mixer recognition device) 228-72652-42
(w/o mixer recognition device) 228-45209-42
MIXER,MR 100 µL
(w/ mixer recognition device) 228-72652-43
(w/o mixer recognition device) 228-45209-43
MIXER,MR 180 µL Ⅱ
(w/ mixer recognition device) 228-72652-44
(w/o mixer recognition device) 228-45209-44
Mixers described above are packaged in a set
Part Name Part No.
Set of Two Mixers MR 40 µL and MR 180 µLⅡ 228-45292-41
Set of Two Mixers MR 100 µL and MR 180 µLⅡ 228-45292-42
Set of Three Mixers MR 40 µL, MR 100 µL and MR 180 µLⅡ 228-45292-43
Recommended Mixers
The table below lists the mixers with the smallest volume among mixers that can be used
in individual combinations of detectors and mobile phases.
Mobile Phase
Solvent Containing
Trifluoroacetic
Acid (TFA)
Solvent Containing
Formic Acid,
Acetic Acid, etc.
Water (Including
Buffer Solution),
Organic Solvent,
or Its Solvent
Mixture
Detector
Photo Diode Array
Detector
MR 180 µL MR 180 µL MR 180 µL
UV Detector MR 180 µL MR 100 µL MR 40 µL
LCMS, LCMSMS - MR 20 µL MR 20 µL
Using a mixer with a volume smaller than the recommendation shown above may cause
excessive fluctuation of the baseline.
When connecting multiple detectors, use a mixer with the largest volume among the
applicable mixers. For example, if using a Photo Diode Array and an LC/MS, the MR 180
µLⅡmixer is recommended.
A larger than recommended mixer can be used to improve mixing performance, but will
also increase the gradient delay volume.
LC-40D X3 CL LC-40D XR CL
5
1.3 Optional Parts
1

Shimadzu LC-40D XR CL Specifications

General

Brand	Shimadzu
Model	LC-40D XR CL
Category	Laboratory Equipment
Language	English