SICK Flexi Soft User Manual

EFI LEDs (FX3-CPU1 main module and higher)
T
able 82: EFI LEDs
LED EFI
(E
FI1 or
EFI2)
Meaning Note
o
OK –
O R
ed
•
W
aiting for integration of EFI-enabled devices
or Flexi Link station following power-up
•
ACR execution (FX3-CPU2 and higher)
–
Ö R
ed
(1Hz)
Error, e.g.,
•
Expec
ted EFI-enabled device or Flexi Link sta‐
tion not found within 3 minutes.
•
Integration check failed
•
Communication interrupted
•
EFI device address conflict
•
Flexi Link ID conflict
•
ACR execution error, e.g., ACR integration
check failed, ACR transmission error (FX3-
CPU2 and higher)
Check the wiring.
Integration at a later date
remains possible at all times.
Ö R
ed
(2Hz, EFI1
and EFI2
alternating)
Identify (e.g., for Flexi Link) –
LINE LED (FX3-CPU3 main module and higher)
T
able 83: LINE LED
LINE LED Meaning
o
Flexi Line is not configured and not in operation.
O Green
Flexi Line in operation
Ö Gr
een (1Hz)
Flexi Line started, waits for neighboring station or
t
each possible, e.g. after system restructuring
Ö Gr
een (2Hz)
Teach-in required
Ö R
ed/green (2Hz)
Flexi Line configuration necessary
Ö R
ed (1Hz)
Error on the Flexi Line bus, e.g., communication interrupted
O R
ed
Serious error, Flexi Line stopped
8.2 Status messages for the FX3-XTIO I/O module
For information on the positions of the LEDs on the FX3-XTIO I/O module, see
figure 31,
page 56.
OPERATION 8
8012478/1IG6/2023-02-24 | SICK O P E R A T I N G I N S T R U C T I O N S | Flexi Soft Modular Safety Controller
107
Subject to change without notice

SICK Flexi Soft Specifications

General

Safety Integrity Level (SIL)	SIL3
Performance Level (PL)	PL e
Programming	Flexi Soft Designer
Power Supply	24 V DC
Safety Protocols	PROFIsafe, CIP Safety
Protection Class	IP20
Number of I/Os	Configurable
Operating Voltage	24 V DC
Power Consumption	Depends on configuration
Dimensions (W x H x D)	Varies depending on the module configuration
Weight	Varies depending on the module configuration
Number of Safety Inputs	Configurable
Number of Safety Outputs	Configurable
Safety Standard	IEC 61508, IEC 62061, ISO 13849
Operating Temperature	0°C to +55°C
Response Time	< 10 ms (typical)
Storage Temperature Range	-25°C to +70°C
Relative Humidity	15 % ... 95 %, non-condensing