SICK Flexi Soft User Manual

5 Electrical installation
5.1 Requirements to be met by the electrical installation
WARNING
E
lectrical voltage
There is a risk of injury from electrocution while connecting the devices.
►
Disconnect the power for the entire plant/machine.
WARNING
Unintended start of the plant/machine
The plant/machine could inadvertently start while you are connecting the devices.
►
Disconnect the power for the entire plant/machine.
WARNING
Ine
ffectiveness of the protective device due to non-compliance with safety standards
The target safety-related level may not be achieved in the event of non-compliance.
►
Observe the relevant safety standards (e.g. EN62061, or ENISO13849-1) for
all the safety-related parts of the plant (wiring, connected sensors and control
devices, configuration, external device monitoring).
ELECTRICAL INSTALLATION 5
8012478/1IG6/2023-02-24 | SICK O P E R A T I N G I N S T R U C T I O N S | Flexi Soft Modular Safety Controller
51
Subject to change without notice

SICK Flexi Soft Specifications

General

Safety Integrity Level (SIL)	SIL3
Performance Level (PL)	PL e
Programming	Flexi Soft Designer
Power Supply	24 V DC
Safety Protocols	PROFIsafe, CIP Safety
Protection Class	IP20
Number of I/Os	Configurable
Operating Voltage	24 V DC
Power Consumption	Depends on configuration
Dimensions (W x H x D)	Varies depending on the module configuration
Weight	Varies depending on the module configuration
Number of Safety Inputs	Configurable
Number of Safety Outputs	Configurable
Safety Standard	IEC 61508, IEC 62061, ISO 13849
Operating Temperature	0°C to +55°C
Response Time	< 10 ms (typical)
Storage Temperature Range	-25°C to +70°C
Relative Humidity	15 % ... 95 %, non-condensing