SICK Flexi Soft User Manual

16 Annex
16.1 Conformities and certificates
You can obtain declarations of conformity, certificates, and the current operating
ins
tructions for the product at www.sick.com. To do so, enter the product part number
in the search field (part number: see the entry in the “P/N” or “Ident. no.” field on the
type label).
16.1.1 EU declaration of conformity
Excerpt
T
he undersigned, representing the manufacturer, herewith declares that the product is
in conformity with the provisions of the following EU directive(s) (including all applicable
amendments), and that the standards and/or technical specifications stated in the EU
declaration of conformity have been used as a basis for this.
•
ROHS DIRECTIVE 2011/65/EU
•
EMC DIRECTIVE 2014/30/EU
•
MACHINERY DIRECTIVE 2006/42/EC
16.1.2 UK declaration of conformity
Excerpt
T
he undersigned, representing the following manufacturer herewith declares that this
declaration of conformity is issued under the sole responsibility of the manufacturer.
The product of this declaration is in conformity with the provisions of the following
relevant UK Statutory Instruments (including all applicable amendments), and the
respective standards and/or technical specifications have been used as a basis.
•
Restriction of the Use of Certain Hazardous Substances in Electrical and Elec‐
tronic Equipment Regulations 2012
•
Electromagnetic Compatibility Regulations 2016
•
Supply of Machinery (Safety) Regulations 2008
16.2 Note on standards
Standards are specified in the information provided by SICK. The table shows regional
s
tandards with similar or identical contents. Not every standard applies to all products.
Table 206: Note on standards
Standard Standard (regional)
China
IEC 60068-2-6 GB/T 2423.10
IEC 60068-2-27 GB/T 2423.5
IEC 60204-1 GB/T 5226.1
IEC 60529 GB/T 4208
IEC 60825-1 GB 7247.1
IEC 61131-2 GB/T 15969.2
IEC 61140 GB/T 17045
IEC 61496-1 GB/T 19436.1
IEC 61496-2 GB/T 19436.2
IEC 61496-3 GB 19436.3
IEC 61508 GB/T 20438
16 ANNEX
188
O P E R A T I N G I N S T R U C T I O N S | Flexi Soft Modular Safety Controller 8012478/1IG6/2023-02-24 | SICK
Subject to change without notice

SICK Flexi Soft Specifications

General

Safety Integrity Level (SIL)	SIL3
Performance Level (PL)	PL e
Programming	Flexi Soft Designer
Power Supply	24 V DC
Safety Protocols	PROFIsafe, CIP Safety
Protection Class	IP20
Number of I/Os	Configurable
Operating Voltage	24 V DC
Power Consumption	Depends on configuration
Dimensions (W x H x D)	Varies depending on the module configuration
Weight	Varies depending on the module configuration
Number of Safety Inputs	Configurable
Number of Safety Outputs	Configurable
Safety Standard	IEC 61508, IEC 62061, ISO 13849
Operating Temperature	0°C to +55°C
Response Time	< 10 ms (typical)
Storage Temperature Range	-25°C to +70°C
Relative Humidity	15 % ... 95 %, non-condensing