Siemens SIDOOR ATD4 W Series - Page 197

Parameter ID Adjustment range Factory set‐
ting
Unit Description
p2205 0..500 0 cm Initial operation:
Because the absolute position is not known in initial
operation, the width in Close direction is speci󹪝ed here
starting from the current position.
0 ≙ area deactivated.
Speci󹪝c door range of motion
p3686 See p3682 corresponding motor type in
section Pro󹪝les and adjustment ranges
(Page 329)
N Force limit in speci󹪝c door range in OPEN direction
p3687 See p3683 corresponding motor type in
section Pro󹪝les and adjustment ranges
(Page 329)
N Force limit in speci󹪝c door range in CLOSE direction
p3688 See p3664 corresponding motor type in
section Pro󹪝les and adjustment ranges
(Page 329)
mm/s Speed limit in speci󹪝c door range in OPEN direction
p3689 See p3668 corresponding motor type in
section Pro󹪝les and adjustment ranges
(Page 329)
mm/s Speed limit in speci󹪝c door range in CLOSE direction
Obstruction and reversing parameters
Table 5-34 Obstruction and reversing parameters (general)
Parameter ID Adjustment range Factory set‐
ting
Unit Description
General
p3850
1)
0..255
Bit x = 1 ≙ function acti‐
vated
Bit x = 0 ≙ function de‐
activated
255 — Function control
Bit 0 ≙ stop obstruction detection in the closing direc‐
tion
Bit 1 ≙ force obstruction detection in the closing direc‐
tion
Bit 2 ≙ obstruction counter in the closing direction
Bit 3 ≙ slow obstruction approach in the closing direc‐
tion
Bit 4 ≙ stop obstruction detection in the opening di‐
rection
Bit 5 ≙ force obstruction detection in the opening di‐
rection
Bit 6 ≙ obstruction counter in the opening direction
Bit 7 ≙ slow obstruction approach in the opening di‐
rection
1)
Expert parameters, see section Expert con󹪝guration (Page 90).
Controllers
5.9 Operation and con󹪝guration of the control unit
ATD4xxW for industrial applications
System Manual, 06/2022, A5E51901827B AA 195