Description
3.2 SINAMICS G110M converter
SINAMICS G110M Operating Instructions
Operating Instructions, 04/2015, FW V4.7.3, A5E31298649B AD
25
Table 3- 2 CU240M Terminal Housing (including the Control Module)
Mains / 24 V DC connections
USS FS80/90 Cable glands 6SL3544-0MB02-1BA0
PROFIBUS FS71 Cable glands 6SL3544-0LB02-1PA0
AS-i FS100/112 HanQ 4/2 / 7/8" 6SL3544-0QB02-1MA0
Every SINAMICS G110M is delivered with the following accessories:
● PTC connection cable - this is the extension cable used to connect the PTC wires from
the motor to the connection on the CPI board.
● EM brake cable - this the extension cable used to connect the EM brake wires from the
motor to the mains connector when the EM brake wire is too short.
● Pre-wired motor terminal cables ready for connecting to the motor terminals on the motor.
● Earthing cable for earthing the motor to the terminal housing (except FS80/90).
● PROFIBUS Communications cable for connecting the CPI board to the communications
connection on the Control Module.
SINAMICS G110M HanQ 4/2 variant
● Male and female HanQ connectors, one of which is pre-wired with pins crimped on the
other end ready for assembly.
● Blanking cap for users not wishing to utilize the power-through daisy chain.
To Next Page
Loading...
