1
1-15
Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
General Preparations
1.1 Preconditions
This Installation and Start-Up Guide describes the procedure for starting up the
basic control functions including drive-related functions. More detailed informa-
tion about special NCK, MMC, PLC or drive functions can be found in the De-
scriptions of Functions/Manuals (see “Documentation requirements”).
You will need the following software to start up the SINUMERIK 840D:
1. PCIN 4.4 for transmission of data to/from MMC
Order no.: 6FX2 060–4AA00–2XB0 (German, English, French), order from:
WK Fürth
2. Start-up tool for digital SIMODRIVE 611 (applies only to MMC100)
Order No. 6FC5 255–jAX00–0AB0, supplies on 3.5” floppies
3. SIMATIC Step7 HiGraph
4. Toolbox for SINUMERIK 840D
Order No. 6FC5 252–jAX21–0AB0
Supplied on 3.5” floppies:
– Basic PLC program
– Standard machine data blocks
– NC variable selector
5. Applies only to MMC100: Software for creating PLC alarm texts and for
transmission to MMC100 (integrated in MMC 100 system software)
You will need the following equipment and accessories to start up the
SINUMERIK 840D:
1. Programming device with MPI interface (PG740)
2. MPI cable for PG740
3. V.24 cable with 9-way connector (female)
Introduction
Software
requirements
Equipment and
accessory
requirements
1
To Next Page
Loading...
Need help?
General
