8
03.96
8.1 Alarm and message texts
8-186
Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
8.1 Alarm and message texts
8.1.1 Alarm text files for MMC 100
The installation routine stored on the MMC100 application diskette (see Sec-
tion 12) transfers
S configuration settings,
S texts,
S the configured interface and
S the user software
from the update directory on your PC/PG to the MMC100 hardware. The ways
in which the alarm text files can be adapted beforehand are described here.
S PC with DOS 6.x
S V.24 cable between the COM1 interface of the MMC100 (X6) and the COM1
or COM2 interface of your PC
S Approx. 3 MB free space on hard disk
S The following description is based on the assumption that you have already
transferred the software from the supplied MMC100 application diskette
(no. 2) of the hard disk of your PC/PG as described in Section 12.
The texts are stored with the Siemens standard entries in the hard disk drive
you have selected on your PC. To simplify matters, this disk drive is always re-
ferred to as C: in the following description. The directory is:
C:\mmc 100 pj\proj\text\<LANGUAGE DIRECTORY>.
Depending on the selected language, one of the following letters stands for
<LANGUAGE DIRECTORY>:
D for German
G for English
F for French
E for Spanish
I for Italian
The alarm file names start with “a” and end in the extension .txt.
– ALZ.TXT Cycle alarm texts
– ALC.TXT Compile cycle alarm texts
– ALP.TXT PLC alarm/message texts
Description
Preconditions
Alarm texts/
message texts
Files
8 Alarm and Messa
e Texts
To Next Page
Loading...
Need help?
General
