1
03.96
1.2 Standard/export version
1-16
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
You will need the following documentation to start up the SINUMERIK 840D:
1. Catalog NC 60.1, Ordering Information/BU/
Order no.: E86060–K4460–A101–A6
2. Manual /PHD/
Order no.: 6FC5 297–5AC10–0BP2
3. Operator Components Manual /BH/
Order no.: 6FC5 297–5AA50–0BP2
4. Description of Functions, Basic Machine (Part 1) /FB/
Order no.: 6FC5 297–5AC20–0BP2
5. Description of Functions, Drive Functions /FBA/
Order no.: 6SN1 197–0AA80–0BP5
6. Lists /LIS/
Order no.: 6FC5 297–5AB70–0BP2
7. Description PCIN 4.4 /PI/
Order no.: 6FX2 060–4AA00–4XB0
8. Diagnostics Guide /DA/
Order no.: 6FC5 297–5AA20–0BP2
1.2 Standard/export version
On account of the approval required for certain control functions as stipulated in
the German Export List, two configuration variants are available for the
SINUMERIK 840D.
The standard version (840D) can contain the full scope of functions of the
control but this does mean that it requires export approval with regard to its
type.
In the export version (840DE) the following options are not available:
S Interpolation with more than 4 axes
S 5-axis milling package
S Helical interpolation 2D + n (n greater than 2)
S OEM package
The following restrictions apply to options that can be used:
S Sag compensation is restricted to the traversing of a path of up to 10 mm.
S Adaptive control
The corresponding option bits can be set but they have no effect (alarm when
programming the functions). The export version requires no export approval
with respect to its type.
Up-to-date information about types and scope of options can be found in
References: /BU/ Catalog NC 60.1.
(If a requirement exists for export approval with respect to the intended use this
is not affected and might even exist in addition.)
Documentation
requirements
Export approval
1 General Preparations
04.00
To Next Page
Loading...
Need help?
General
