1
03.96
1.2 Standard/export version
1-17
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
The specific nature of the control is determined by the system software that is
available in two versions (standard and export). In other words, the
requirements for approval of the system software (refer also to the delivery
notes or invoice for information in this respect) is handed down to the control
system with the installation. This point must be observed in particular when
converting or upgrading the system software because the requirements for
export approval for the control can change accordingly.
In addition to the information provided on the delivery note and invoice, the
hardware components supplied with the system software are also clearly
identified by adhesive labels as standard or export versions.
Note
The adhesive labels supplied additionally in the packaging are intended to
identify the control after installation and start-up and must be pasted into the
control logbook. In the case of license orders, a corresponding number of
labels is provided and the same applies to these.
When the control has been booted, the export versions can be identified by the
additional character ’E’ in the Service screen (NC information). The identification
of the control variants obtained by these measures is important for service
personnel and can also be helpful in providing evidence of conformance for
exports, in particular when making use of the negative certificates that are
provided for the export version.
J
Identification of
the
control
1 General Preparations
To Next Page
Loading...
Need help?
General
