Siemens SINUMERIK 810D Installation And Startup Guide

10
03.96
10.8 Trace function (SW 4.2 and higher)
10-224
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
10.8.3 Parameterization
In the basic display you can select
S The axis/spindle to be measured
S The signal to be measured
S The duration of measurement
S The triggering time
S The type of triggering
S The triggering threshold
The cursor must be positioned on the “Axis/spindle name” list box of the trace
concerned. You can select it with the softkeys Axis+ and Axis– or by accepting
a value from the dropdown list.
The cursor must be on the “Signal selection” list box of the trace concerned.
You can select a value by accepting it from the dropdown list.
Parameterization
in the basic
display
Signal selection
Input field
axis/spindle name
Input field
Signal selection
10 Drive Optimization with Start-Up Tool
05.98

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English