10
03.96
10.4 Aborting measuring functions
10-210
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
10.4 Aborting measuring functions
S Emergency stop
S NC stop
S Reset (mode group, channel)
S Feed override = 0
S Spindle override = 50
S No controller enabling command
S Change in operating mode (JOG) or operating mode JOG not selected
S Actuation of traversing keys
S Actuation of handwheel
S No traversing enable signals
S Alarms leading to axis shutdown
S Hardware limit switch reached
S Traversing range limits exceeded
S Selection of parking (in position-controlled operation)
10 Drive Optimization with Start-Up Tool
To Next Page
Loading...
