11
11-245
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
Data Backup
11.1 General information
You should save your data
S after start-up,
S after changing machine-specific settings,
S during servicing (e.g. after replacing hardware, upgrading software) so that
you can put the system back into operation as soon as possible and
S during start-up before altering the memory configuration to make sure that
no data are lost during start-up.
There are three types of data to be saved with the SINUMERIK 840D, i.e.
1. Saving data for NCK, drive and operator panel settings
2. Saving data for PLC
3. Saving data for MMC when MMC 101/102/103 is installed
When to save data
NCK/PLC/MMC
11
To Next Page
Loading...
Need help?
General
