8
03.96
8.1 Alarm and message texts
8-190
Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
8.1.3 Alarm text files for HPU
The alarm text files for the NC and PLC are created and incorporated in the
same manner as for the MMC 100.
The installation routine “HPUSETUP” on the HPU system diskette transfers
S configuration settings,
S texts,
S the configured interface and
S the user software
from the update directory on your PC/PG to the HPU hardware. The ways in
which the alarm text files can be adapted beforehand are described here.
S PC with DOS 6.x
S V.24 cable between the COM1 interface of the HPU and the COM1 or
COM2 interface of your PC
S Approx. 3 MB free space on hard disk
S The following description is based on the assumption that you have already
transferred the software from the supplied system diskette to the hard disk of
your PC/PG as described in ReadMe file supplied.
1. Call HPUSETUP
2. Once you have copied the software to the hard disk, exit the installation pro-
cedure (“NO”).
3. Modify the alarm text files in <INSTALLATION DIRECTORY>
\proj_hpu\text\al\...
4. After the text contents have been modified, the text files must be converted
(“Mkalarm”) and transferred to the HPU.
5. Call INSTALL in the <INSTALLATION DIRECTORY>.
The texts are stored with the Siemens standard entries in the hard disk drive
you have selected on your PC. To simplify matters, this disk drive is always re-
ferred to as C: in the following description. The directory is:
C:\hpu_dvk\proj_hpu\text\al\<LANGUAGE DIRECTORY>.
Depending on the selected language, one of the following letters stands for
<LANGUAGE DIRECTORY>:
D for German
G for English
F for French
E for Spanish
I for Italian
Description
Preconditions
Procedure
Alarm texts/
message texts
8 Alarm and Messa
e Texts
05.99
To Next Page
Loading...
Need help?
General
