10
03.96
10.1 Instructions for use
10-206
Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
10.1.3 Starting the program
To start the start-up tool on a PG/PC, go to the file manager and double-click on
the file REG_CMD.EXE or select a user-defined icon in the Application group. If
it is not possible to communicate with the NCK, then the message “No commu-
nication with NCK” is output. If communication is interrupted, e.g. through an
NCK reset, then the start-up tool tries to reestablish the link automatically.
10.1.4 Terminating the program
The start-up tool is deselected by the following actions:
S Press function key F10
S You can terminate the program by activating the Exit softkey.
Calling the
program
Deselecting the
program
10 Drive Optimization with Start-Up Tool
To Next Page
Loading...
