Siemens SINUMERIK 810D

10
03.96
10.10 Automatic controller setting (only MMC 103, SW 4.3 and higher)
10-237
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
1
2
Start mech.
measurement
part 2?
SK “OK”
Confirm NC Start prompt
Caution:
When you activate NC Start, the
axis starts to move!
SK “Parameter”
Enter measur.
parameters
SK “Cancel”
(discard
changes)
SK “OK”
(accept
values)
Start mea-
surement
of current
control
loop?
SK “OK”
Confirm NC Start prompt
Caution:
When you activate NC Start, the
axis is operated in current control
mode!
SK “Parameter”
Enter measur.
parameters
SK “Cancel”
(discard
changes)
SK “OK”
(accept
values)
10 Drive Optimization with Start-Up Tool
05.9805.98