10
03.96
10.10 Automatic controller setting (only MMC 103, SW 4.3 and higher)
10-239
Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
End
3
Do you want to save
boot file for drive X and
display modified
controller data?
SK “Yes”
SK “No”
Boot file is
not saved
Start mea-
surement
of speed con-
troller?
SK “OK”
Confirm NC Start prompt
Caution:
When you activate NC Start, the
axis starts to move!
SK “Parameter”
Enter measur.
parameters
SK “Cancel”
(discard
changes)
SK “OK”
(accept
values)
Boot file is
saved
3
10 Drive Optimization with Start-Up Tool
05.9805.98
To Next Page
Loading...
