Siemens SINUMERIK 810D

6 Assi
g
nin
g
Parameters to the Control and the PLC Pro
g
ram
6
03.96
6-86
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
6.10.4 Mounting dimensions 6-165. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.10.5 Temperature sensor for 1FN1 and 1FN3 motors 6-166. . . . . . . . . . . . . . . . .
6.10.6 Measuring system 6-169. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.10.7 Parallel connection of linear motors 6-172. . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.10.8 Test measurements on linear motor 6-174. . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.11 AM/V/Hz function 6-176. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.12 System settings for power up, RESET and part program start 6-177. . . . . .
04.00