Detailed description
2.12 Block descriptions
Basic logic functions: PLC Basic program powerline (P3 pl)
142 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
Unload function
The tool specified by the tool number is unloaded at the specified loading point/station
(location_number_to, magazine_number_to), i.e., the magazine is traversed to the position
for unloading and the tool is then removed. The magazine location for the tool is marked as
being free in the TP block. The tool can be specified either via a T number or by means of
the location and magazine numbers. The value -1 is entered at unused specification points.
Note
Before and after this PI service, the MMCSEM PI service must be called with the associated
parameter "WVar1" for this PI service. See PI service MMCSEM for more information.
Parameterization
Signal Type Value range Meaning
PIService ANY PI.TMMVTL Make magazine
location ready for
loading, unload tool
Unit INT 1, 2 TOA
WVar1 INT T number
WVar2 INT Location_number_from
WVar3 INT Magazine_number_fro
m
WVar4 INT Location_number_to
WVar5 INT Magazine_number_to
To Next Page
Loading...
Need help?
General
