EasyManuals Logo

Siemens SINUMERIK 810D Function Manual

Siemens SINUMERIK 810D
2184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
Detailed description
2.1 NC/PLC interface signals
Basic logic functions: Various NC/PLC interface signals and functions (A2)
26 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
Stored hardware input
Setpoint enable (terminal 64)
"Status ready for traverse" (terminal 72/73)
No 611D drive alarm (DClink1 error)
DC link connected
Ramp-up completed
See also:
DB31, ... DBX93.7 (pulses enabled)
2.1.10 Signals from axis/spindle (digital drives)
DB31, ... DBX92.0 (setup mode active)
On the drive, "setup mode" is active.
DB31, ... DBX92.1 (ramp-function-generator fast stop active) (not on 810D)
The drive signals back to the PLC that ramp-function-generator fast stop is active. The drive
is thus brought to a standstill without the ramp function (with speed setpoint 0).
DB31, ... DBX92.2 (torque limit 2 active) (not on 810D)
The drive signals back to the PLC that torque limit 2 is active for the axis/spindle. The torque
limit value is defined with the drive parameters.
DB31, ... DBX92.3 (speed-setpoint smoothing active) (not on 810D)
The PLC user program requests speed-setpoint smoothing filter for the axis/spindle. The
smoothing is activated in the drive module only under certain conditions.
DB31, ... DBX93.0, 1, 2 (active drive parameter set A, B, C)
The drive module sends this checkback to the PLC to indicate which drive parameter set is
currently active. With bit combination A, B, C, eight different drive parameter sets can be
selected by the PLC for the SIMODRIVE 611D.

Table of Contents

Other manuals for Siemens SINUMERIK 810D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 810D and is the answer not in the manual?

Siemens SINUMERIK 810D Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 810D
CategoryControl Unit
LanguageEnglish

Related product manuals