EasyManuals Logo

Siemens SINUMERIK 810D Function Manual

Siemens SINUMERIK 810D
2184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1721 background imageLoading...
Page #1721 background image
Basic logic functions: Feeds (V1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
5
Brief Description
1
Types of feedrate
The feedrate determines the machining speed (axis or path velocity) and is observed in
every type of interpolation, even where allowance is made for tool offsets on the contour or
on the tool center point path (depending on G commands).
The following types of feedrate allow optimum adaptation to the various technological
applications (turning, milling, drilling, etc.):
Rapid traverse feedrate (G0)
Inverse-time feedrate (G93)
Linear feedrate (G94)
Revolutional feedrate (G95)
Constant cutting rate (G96, G961)
Constant speed (G97, G971)
Feedrate with thread cutting (G33, G34, G35)
Feedrate for tapping with compensating chuck (G63)
Feedrate for rigid tapping (G331, G332)
Feedrate for chamfer/rounding FRC, FRCM
Non-modal feedrate FB
Programmable run-in/run-out path for G33
The thread run-in and run-out paths can be programmed. The thread axis is accelerated and
decelerated within the defined distance.
Note
If a very short distance is specified, the axis can be overloaded.

Table of Contents

Other manuals for Siemens SINUMERIK 810D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 810D and is the answer not in the manual?

Siemens SINUMERIK 810D Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 810D
CategoryControl Unit
LanguageEnglish

Related product manuals