EasyManuals Logo

Siemens SINUMERIK 810D Function Manual

Siemens SINUMERIK 810D
2184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1304 background imageLoading...
Page #1304 background image
Detailed description
2.5 Linking PLC CPUs to 840D
Basic logic functions: PLC basic program solution line (P3 sl)
30 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
Interface MCP/PLC, interface HHU/PLC (Ethernet link)
MCP/PLC and HHU (HT2) /PLC data exchange takes place via the integrated CP's Ethernet
bus. The CP transfers the MCP/HHU signals to and fetches them from the PLC's internal
DPR (Dual-Port RAM). On the PLC side, the basic program handles communication with the
user interface. The basic-program parameters (FB1, DB7) define the operand areas (e.g.
I/O) and the start addresses.
Interface MCP/PLC (Profibus link)
MCP/PLC data exchange takes place via the PLC's Profibus. The MCP's I/O addresses
must be set in the PLC's process image area and via HW configuration in STEP7. The
MCP*In, MCP*Out pointer variables must be set to the same addresses. The selected DP
slave number must be entered in MCP*BusAdr.
Interface MCP/PLC, interface HHU/PLC (MPI link)
is no longer supported
2.5.4 Diagnostic buffer on PLC
General
The diagnostic buffer on the PLC, which can be read out using STEP7, contains diagnostic
information about the PLC operating system.

Table of Contents

Other manuals for Siemens SINUMERIK 810D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 810D and is the answer not in the manual?

Siemens SINUMERIK 810D Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 810D
CategoryControl Unit
LanguageEnglish

Related product manuals