EasyManuals Logo

Siemens SINUMERIK 810D Function Manual

Siemens SINUMERIK 810D
2184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #631 background imageLoading...
Page #631 background image
Detailed description
2.6 Block search Type 5 SERUPRO
Basic logic functions: Mode group, channel, program operation, reset response (K1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
73
G331/G332 causes the spindle to be interpolated as an axis in a path grouping. In the
case of tapping, the drilling depth (e.g., axis X) and the pitch and speed (e.g., spindle S)
are specified.
In the case of DryRun, the velocity of X is specified, the speed remains constant, and the
pitch is adjusted.
Following the SERUPRO simulation, the position for spindle S deviates from the normal
position because the spindle S has rotated less during simulation.
2.6.3 SERUPRO ASUP
SERUPRO ASUB special points
Special points should be noted for SERUPRO ASUB with regard to:
Reference point approach: Referencing via part program G74
Tool management: Tool change and magazine data
Spindle ramp-up On starting a SERUPRO ASUB
G74 reference point approach
If statement G74 (reference point approach) is programmed between the program start and
the search target, this will be ignored by the NC.
SERUPRO approach does not take this G74 statement into account!
Tool management
If tool management is active, the following setting is recommended:
Set MD18080 $MA_TOOL_MANAGEMENT_MASK BIT 20 = 0.
The tool management command generated during the SERUPRO operation is thus not
output to the PLC!
The tool management command has the following effect:
The NC acknowledges the commands automatically.
No magazine data are changed.
Tool data are not changed.
Exception:
The tool enabled during the test mode can assume 'active' status. As a result, the spindle
may contain the incorrect tool after the SERUPRO operation.
Remedy:
The user starts a SERUPRO ASUB that is actually traversed. Prior to the start, the user
can start an ASUB that loads the correct tool.
SERUPRO operation: Functionality: In sequence steps 2. to 6.
SERUPRO ASUB: Functionality: The sequence of point 7.

Table of Contents

Other manuals for Siemens SINUMERIK 810D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 810D and is the answer not in the manual?

Siemens SINUMERIK 810D Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 810D
CategoryControl Unit
LanguageEnglish

Related product manuals