Basic logic functions: Feeds (V1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
9
Detailed description
2
2.1 Path feedrate F
2.1.1 General
Path feedrate F
The path feedrate represents the geometrical total of the velocity components in the
participating axes. It is therefore generated from the individual motions of the interpolating
axes.
The default uses the axial velocities of the geometry axes which have been programmed.
The FGROUP command can be used to include other geometry and/or synchronized axes in
the calculation of the path feedrate.
The path feedrate F determines the machining speed and is observed in every type of
interpolation even where allowance is made for tool offsets. The value programmed under
the address F remains in the program until a new F value or a new type of feedrate is
programmed.
Value range for path feedrate F
Reference:
/PG/ Fundamentals Programming Guide
/FB1/ Function Manual, Basic Functions; Velocities, Setpoint/ Actual Value Systems, Closed-
Loop Control (G2)
F value at PLC interface
The F value of the current path feedrate is always entered in the channelspecific PLC
interface for auxiliary functions (DB21, ... DBB158 bis 193).
The related interface signals (modification signal, F value) are described in:
References:
/FB1/ Function Manual Basic Functions; Auxiliary Function Output to PLC (H2)
To Next Page
Loading...
Need help?
General
