EasyManuals Logo

Siemens SINUMERIK 810D Function Manual

Siemens SINUMERIK 810D
2184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1741 background imageLoading...
Page #1741 background image
Detailed description
2.1 Path feedrate F
Basic logic functions: Feeds (V1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
25
Alarms
Thread cutting G33, G34, G35
The following alarms are output when programming is incorrect:
Alarm 10604 "Thread lead increase too high"
Alarm 10605 "Thread lead decrease too high"
Alarm 10607 "Thread with frame (ROT) cannot be executed"
Alarm 16005 "Illegal lift-off path"
Alarm 16710 "Master spindle not programmed"
Alarm 16720 "Thread lead is zero"
Alarm 16730 "Incorrect parameters"
Alarm 16740 "No geometry axis programmed"
If the spindle speed is too high when G33, G34, G35 are active, e.g., spindle override set
to 200%, alarm 22270 "Spindle speed for thread cutting too high" is output.
Alarm 22270 is output when the rapid traverse speed of the thread axis is exceeded. It is
possible to reduce the spindle speed using the spindle override switch to prevent serious
alarms.
References:
/FB1/ Function Manual, Basic Functions; Diagnostic Tools (D1);
Chapter: General Machine Data
/DA/ Diagnostics Guide
2.1.4.4 Stop for thread cutting
Stop for thread cutting
Note
The nondestructive interrupt function should only be used for thread cutting, not for tapping
with G33.

Table of Contents

Other manuals for Siemens SINUMERIK 810D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 810D and is the answer not in the manual?

Siemens SINUMERIK 810D Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 810D
CategoryControl Unit
LanguageEnglish

Related product manuals