Glossary
Basic logic functions: Appendix
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
25
Inverse-time feedrate
With SINUMERIK 840D, the time required for the path of a block to be traversed can be
programmed for the axis motion instead of the feed velocity (G93).
JOG
Control operating mode (setup mode): In JOG mode, the machine can be set up. Individual
axes and spindles can be traversed in JOG mode by means of the direction keys. Additional
functions in JOG mode include: → Reference point approach, → Repos, and → Preset (set
actual value).
Key switch
The key switch on the → machine control panel has 4 positions that are assigned functions
by the operating system of the control. The key switch has three different colored keys that
can be removed in the specified positions.
Keywords
Words with specified notation that have a defined meaning in the programming language for
→ part programs.
Leading axis
The leading axis is the → gantry axis that exists from the point of view of the operator and
programmer and, thus, can be influenced like a standard NC axis.
Leadscrew error compensation
Compensation for the mechanical inaccuracies of a leadscrew participating in the feed. The
control uses stored deviation values for the compensation.
Limit speed
Maximum/minimum (spindle) speed: The maximum speed of a spindle can be limited by
specifying machine data, the → PLC or → setting data.
Linear axis
In contrast to a rotary axis, a linear axis describes a straight line.
Linear interpolation
The tool travels along a straight line to the destination point while machining the workpiece.
Load memory
The load memory is the same as → RAM for the CPU 314 of the → SPS.
To Next Page
Loading...
Need help?
General
