Glossary
Basic logic functions: Appendix
32 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
Rounding axis
Rounding axes rotate a workpiece or tool to an angular position corresponding to an
indexing grid. When a grid index is reached, the rounding axis is "in position".
Safety Functions
The control is equipped with permanently active montoring functions that detect faults in the
→ CNC, the → PLC, and the machine in a timely manner so that damage to the workpiece,
tool, or machine is largely prevented. In the event of a fault, the machining operation is
interrupted and the drives stopped. The cause of the malfunction is logged and output as an
alarm. At the same time, the PLC is notified that a CNC alarm has been triggered.
Scaling
Component of a → frame that implements axis-specific scale modifications.
Scan cycle
Protected subroutine for implementing a repetitious machining operation on the → workpiece.
Selecting
Series of instructions to the NC-Control that act in concert to produce a particular
→ workpiece. Likewise, this term applies to execution of a particular machining operation on
a given → raw part.
Serial RS-232-C interface
For data input/output, the PCU 20 has one serial V.24 interface (RS232) while the
PCU 50/70 has two V.24 interfaces. Machining programs and manufacturer and user data
can be loaded and saved via these interfaces.
Setting data
Data, which communicates the properties of the machine tool to the NC control, as defined
by the system software.
Softkey
A key, whose name appears on an area of the screen. The choice of soft keys displayed is
dynamically adapted to the operating situation. The freely assignable function keys (soft
keys) are assigned defined functions in the software.
Software limit switch
Software limit switches limit the traversing range of an axis and prevent an abrupt stop of the
slide at the hardware limit switch. Two value pairs can be specified for each axis and
activated separately by means of the → PLC.
To Next Page
Loading...
Need help?
General
